Boost Pressure

Stack’s Pro-Control range of Professional Stepper Motor Analogue Gauges are user configurable with Maximum/Minimum alarms which can be set with one of seven different colours to indicate status.

PROCONTROL gauges Key Features:

• 52mm diameter
• Peak “tell-tale” Memory - Max temps, Min pressures
• Configurable max and min full dial alarm warnings
• Configurable Pro-Control output for activating accessories eg. fans, pumps, etc (requires relay)
• 270° full sweep movement for excellent readability
• Temperature gauges with built-in “fan controller”
• Pressure gauges with built-in “pump controller”
• 0-5 Volt analogue output for data logger or ECU (except EGT and Fuel Level gauges)
• Configurable backlight colour
• Black dialface when powered off
• 7 Colour LED through-the-dial backlighting
• Better than 2% accuracy

These Stack precision auxiliary instruments combine digital microprocessor accuracy with a high-precision stepper motor needle movement, to provide a new level of accuracy and reliability in 52mm gauges. They combine the durability and readability of 270° mechanical gauges with the easy installation and safe operation of conventional electric gauges. 

The 270° dialface together with the new white LED backlighting and illuminated needle ensure excellent readability day or night.

Professional Gauges Key Features:

• 52mm diameter
• Fast, smooth stepper motor needle drive
• 270° full sweep movement for excellent readability
• Remotely mounted solid-state sensors keep hazardous fluids in the engine compartment
• Better than 2% accuracy
• All-electronic design for maximum reliability
• White LED through-the-dial backlighting
• Black dialface with White LED illuminated needle or White dialface with Orange LED illuminated needle

This Stack range of gauges have been specifically designed for vehicles with no or low powered electrical systems.

Mechanical Gauges Key Features:

• 52mm diameter
• Black dialface with White LED illuminated needle or White dialface with Orange LED illuminated needle
• Bronze bourdon tube 270° sweep movement
• Mechanical gauges do not require 12V power to operate. They make direct physical contact with the item they are reading. They do this through tubing or lines, which eliminates the need for electric signals.
• Ideal for vehicles that operate on voltages other than 12V, with no voltage at all (magneto applications) or operate on a battery with no generator.
• Note: 12 volt supply is needed if backlighting required.

52mm Boost Controller Gauge 30 PSI / 2 Bar Applications
• Digital display with radial LED matched to current Wideband Lambda Arrangement
• Modifies mechanical waste gate duty cycle to achieve higher boost pressures than in
place controls would otherwise allow
• Push button programming
• All inclusive kit consists of gauge, wire loom, MAP sensor and 3 port solenoid valve
• Suitable for use with single and twin/bi turbocharged applications
• 4 Programmable control strategies:
o High Boost
o Low Boost
o RPM based mapping
o Gear based mapping
• MAP, RPM, and VehicleSpeed inputs
• Intelligent gear capture
• Peak tell-tale memory
• Pro-Control Output
• Pro-Control Input (interactive with Wideband Lambda gauge design to allow lean alarm condition to trigger boost cut)
• 0-5V datalogger output
• Selectable Units PSI, BAR, kPa
• Digital RPM display
• Optional barometric compensation mode to adjust for changing atmospheric conditions and changes in elevation during operation (e.g. hill climb, rally, etc.)
• Black and White Dial options